Título: | Análisis digital de preparaciones para prótesis fija unitaria |
Autores: | Castro Espinoza, Michelle Alexandra ; Torres Jaramillo, María Camila |
Tipo de documento: | texto impreso |
Fecha de publicación: | 2018-11-22T18:07:25Z |
Dimensiones: | application/pdf |
Idiomas: | Español |
Palabras clave: | Odontología , Facultad de Odontología , Acceso a Tesis Pregrado , Posgrado y Doctoral , Tesis de Pregrado |
Resumen: |
La destreza que adquiere un estudiante para realizar la preparación dental es muy importante para el buen pronóstico del tratamiento prostodóntico. Actualmente, con el avance de la tecnología, han surgido métodos de análisis digital para evaluar las preparaciones dentales de forma objetiva. OBJETIVO: Analizar de manera objetiva las preparaciones dentales para prótesis fija unitaria mediante el software digital Prepcheck®. MATERIALES Y MÉTODOS: La muestra estuvo constituída por 30 preparaciones dentales para coronas unitarias, realizadas en dientes de modelos de Ivorina por los estudiantes de sexto ciclo de la Facultad de Odontología de la Universidad de Cuenca. El tamaño muestral se obtuvo en base al teorema central del límite. Se evaluó los principios de convergencia oclusal total, reducción axial, reducción oclusal, continuidad del margen de la preparación, textura superficial y eje de inserción. RESULTADOS: La convergencia oclusal total y la reducción axial predominaron dentro del rango de tolerancia (10°- 20°; 1-1.5 mm respectivamente).Se encontró una reducción oclusal insuficiente en la mayoría de las preparaciones. Existió un margen continuo a nivel de las caras vestibular y lingual. Todas las preparaciones presentaron una textura superficial lisa. Veinte y dos preparaciones presentaron un eje de inserción adecuado. CONCLUSIÓN: La convergencia oclusal total, la reducción axial y la textura superficial prevalecieron dentro del rango establecido como aceptable. Existió una escasa reducción oclusal. La continuidad del margen se mantuvo en las caras vestibular y lingual. El eje de inserción de la mayoría de preparaciones fue adecuado. The skills acquired by a student to perform dental preparation are very important for a good prognosis of prosthodontic treatment. Nowadays, with the advancement of technology, methods of digital analysis have emerged to evaluate dental preparations objectively. OBJECTIVE: Objectively analyze dental preparations for single dental crowns by using a digital software called Prepcheck®. MATERIALS AND METHODS: 30 dental preparations for single dental crowns were evaluated. Ivorina models were used and the preparations were made by students of the sixth semester of the Faculty of Dentistry of Universidad de Cuenca. The sample size was obtained based on the central limit theorem. The principles of total occlusal convergence, axial reduction, occlusal reduction, continuity of preparation margin, surface texture and insertion axis were evaluated by using Prepcheck® software. RESULTS: Total occlusal convergence and axial reduction predominated within the tolerance range (10 ° - 20 °, 1-1.5 mm respectively). An insufficient occlusal reduction was found in most preparations. There was a continuous margin at the level of the vestibular and lingual faces. All the preparations presented a smooth surface texture. Twenty-two preparations presented an adequate insertion axis. CONCLUSION: Total occlusal convergence, axial reduction and surface texture prevailed within the range established as acceptable. There was a low occlusal reduction. The continuity of the margin remained in the vestibular and lingual faces. The insertion axis of most preparations was adequate. ODONTOLOGO Cuenca |
En línea: | http://dspace.ucuenca.edu.ec/handle/123456789/31636 |
Ejemplares
Estado |
---|
ningún ejemplar |